Kaksi kirurgien käsienpesuallasta

Surgeons’ hand wash basin 7110

Surgeons’ hand wash basin 7110 is designed to facilitate handwashing in operating theatre cleaning facilities in particular. The shape of the basin’s front edge is designed to direct any water dripping from the elbows back into the basin. The polished surface and rounded edges of the hand hygiene basin make the basin easy to disinfect and clean.

The basin can be used for creating a basin group set by joining the basins together.

Product data sheet

Stainless steel AISI 304
Surface treatment
Electric polishing
Measurements of basin (width x depth x height)
A base valve (stench trap isn’t included in the delivery)
Drain connection
KAVIKA OY, Tempo 4, 04430 Järvenpää, Finland
Tel. +358 9 8362 0055, kavika@kavikahealthcare.fi, www.kavika.fi

Kirurgien käsienpesuallas 7110

Further information

Can be manufactured as a basin series or as stand-alone basins. The shape of the basin is designed to facilitate handwashing in operating theatre cleaning facilities. The outer dimensions of a stand-alone basin are 1000x700x150 mm (width x depth x height).

Check whether you want the basins as a series set welded together or as stand-alone basins.

Stainless steel equipment and fixtures must be cleaned on a regular basis to prevent them from rusting. A water wash is often sufficient for cleaning a stainless steel surface; hot water and steam can be used in special cases.

Standard cleaning powders or power detergents such as soda, borax or sodium perborate can be used for cleaning stainless steel surfaces.

Alkaline solutions, such as soda, ammonia and diluted soda lye, can be used for dissolving grease. Acetone, petrol, alcohol and similar organic solvents can also be used for removing grease deposits or other water-insoluble matter.

Detergents that contain sulphuric or hydrochloric acid may not be used for cleaning stainless steel surfaces.

The sterilising agents used for disinfection often contain sodium hypochlorite or potassium hypochlorite. However, these substances are dangerous to stainless steel as they easily give rise to pitting corrosion. Other disinfectants that contain chlorine, such as chloramines, are also dangerous. The most affordable disinfectant that is suitable for stainless steel is nitric acid; even mild concentration solutions have a bactericidal effect.

The detergent must be carefully cleaned from the steel surface. Rinsing with plenty of water is usually sufficient for this purpose. If acidic detergents are used, a pre-rinse should be carried out with a neutralising solution, such as soda.

The user must always ensure that the room concerned is sufficiently ventilated, proper protective gear is used and any in-house occupational heath and safety instructions are complied with.