Gypsum separators


Gypsum separator 3140

Gypsum separator 3140 is made of acid-proof steel. It is equipped with a water discharge tap, and the lower part can be easily detached and emptied.

The separator is installed into the washbasin discharge pipe and mounted with screws onto the wall behind the table. The discharge pipe is connected to the floor drain with a separate plastic hose. The plastic hose is not included in the delivery.

  • Upper part dimensions: Ø285×110+35 mm drain valve
  • Lower part dimensions: Ø260×215 mm
  • Accessories: 35 mm drain valve, 32 mm drain pipe, tap and Urho latches, 2 pcs

For the designer

Suitable for separating gypsum and other heavier-than-water matter from water. Made of acid-proof steel.

For the buyer

Wall brackets are included in the delivery.

Maintenance and use

Stainless steel equipment and fixtures must be cleaned on a regular basis to prevent them from rusting. A water wash is often sufficient for cleaning a stainless steel surface; hot water and steam can be used in special cases.

Impurities and deposits that have adhered to the surface can be removed by rubbing them with an emery cloth, for example. NOTE! The emery cloth must be non-ferrous. It is advisable to first try the treatment on a less noticeable part of the product.

Standard cleaning powders or power detergents such as soda, borax or sodium perborate can be used for cleaning stainless steel surfaces.

Alkaline solutions, such as soda, ammonia and diluted soda lye, can be used for dissolving grease. Acetone, petrol, alcohol and similar organic solvents can also be used for removing grease deposits or other water-insoluble matter.

Detergents that contain sulphuric or hydrochloric acid may not be used for cleaning stainless steel surfaces.

The sterilising agents used for disinfection often contain sodium hypochlorite or potassium hypochlorite. However, these substances are dangerous to stainless steel as they easily give rise to pitting corrosion. Other disinfectants that contain chlorine, such as chloramines, are also dangerous. The most affordable disinfectant that is suitable for stainless steel is nitric acid; even mild concentration solutions have a bactericidal effect.

Treatment after cleaning
The detergent must be carefully cleaned from the steel surface. Rinsing with plenty of water is usually sufficient for this purpose. If acidic detergents are used, a pre-rinse should be carried out with a neutralising solution, such as soda.

The user must always ensure that the room concerned is sufficiently ventilated, proper protective gear is used and any in-house occupational heath and safety instructions are complied with.

Scroll to Top