,

Slop sinks

Description

Slop sink 3180 is a wall-mounted sink with edge flushing that is well-suited for laboratories and for pouring and flushing excretions, small tissue fragments etc. into the drain. The sink is flushed using the push-button tap.

Sinks 3181 and 3182 are mounted on to the sink, work table or fume cupboard top. In addition to mechanical rinsing, a touch-free mechanism can be used.

A slop closet is recommended for flushing larger disposable solid and fluid waste.

Product data sheet

Techical information

Models
3180 Slop sink
3181 Slop sink mountable on to table, push button rinsing
3182 Slop sink mountable on to table, touch-free rinsing

Material
Acid-proof steel AISI 316

Sink measurements (width x depth x height)
3180 400x400x270 mm
3181 Ø250×300 mm
3182 Ø250×300 mm

Accessories
3180 hinged grid
3181 removable lid available
3182 removable lid available
Plastic trap

Connections
Cold water connection DN15-connection (4,0–8,0 bar pressure)
3180: Drain connection DN70
3181 and 3182: 1 ½ inch external thread

Flush valve
Depending on the model
Manual Franke Aqualine AQRM464
Touch-free Franke Protronic AQUA402

Installation
3180 installation height: 320mm lower mount and approx. 900mm upper abutment (mounting distance 180m)
mountable into wall with screws
water and drain connections

Manufacturer
Kavika HealthCare Oy, Mursketie 6, 15860 Hollola
contact@kavikahealthcare.fi, www.kavikahealthcare.fi

For the designer

The cold water supply is connected to the slop sink with a DN15 connection. Discharge is connected to a DN70 drain line.

For the buyer

Check the intended use of the slop sink and contact our sales department. We will help you to choose the right model.

Maintenance and use

Cleaning
Stainless steel equipment and fixtures must be cleaned on a regular basis to prevent them from rusting. A water wash is often sufficient for cleaning a stainless steel surface; hot water and steam can be used in special cases.

Impurities and deposits that have adhered to the surface can be removed by rubbing them with an emery cloth, for example. NOTE! The emery cloth must be non-ferrous. It is advisable to first try the treatment on a less noticeable part of the product.

Detergents
Standard cleaning powders or power detergents such as soda, borax or sodium perborate can be used for cleaning stainless steel surfaces.

Alkaline solutions, such as soda, ammonia and diluted soda lye, can be used for dissolving grease. Acetone, petrol, alcohol and similar organic solvents can also be used for removing grease deposits or other water-insoluble matter.

Detergents that contain sulphuric or hydrochloric acid may not be used for cleaning stainless steel surfaces.

Disinfection
The sterilising agents used for disinfection often contain sodium hypochlorite or potassium hypochlorite. However, these substances are dangerous to stainless steel as they easily give rise to pitting corrosion. Other disinfectants that contain chlorine, such as chloramines, are also dangerous. The most affordable disinfectant that is suitable for stainless steel is nitric acid; even mild concentration solutions have a bactericidal effect.

Treatment after cleaning
The detergent must be carefully cleaned from the steel surface. Rinsing with plenty of water is usually sufficient for this purpose. If acidic detergents are used, a pre-rinse should be carried out with a neutralising solution, such as soda.

The user must always ensure that the room concerned is sufficiently ventilated, proper protective gear is used and any in-house occupational heath and safety instructions are complied with.

Scroll to Top